The first time I performed PCR was in 1992. I was finishing my Bachelors in Genetics and had an independent study project in a population genetics laboratory. My task was to try using a new technique, RAPD PCR, to distinguish clonal populations of the sea anemone, Metridium senile. These creatures can reproduce both sexually and asexually, which can make population genetics studies challenging. My professor was looking for a relatively simple method to identify individuals who were genetically identical (i.e., potential clones).

PCR was still in its infancy. No one in my lab had ever tried it before, and the department had one thermal cycler, which was located in a building across the street. We had a paper describing RAPD PCR for population work, so we ordered primers and Taq DNA polymerase and set about grinding up bits of frozen sea anemone to isolate the DNA. [The grinding process had to be done using a mortar and pestle seated in a bath of liquid nitrogen because the tissue had to remain frozen. If it thawed it became a disgusting mass of goo that was useless—but that is a topic for a different blog.] Since I had never done any of the procedures before, my professor and I assembled the first set of reactions together. When we ran our results on a gel, we had all sorts of bands—just what he was hoping to see. Unfortunately, we realized that we had added 10X more Taq DNA polymerase than we should have used. I repeated the amplification with the correct amount of Taq polymerase, and I saw nothing.

At that time, there was not a lot of information available for PCR optimization. I wish that I had had a list like the one below to follow:

Top 10 things you can do to improve your PCR results

10. Modify your reaction buffer composition to adjust pH and salt concentrations.

9. Titrate the amount of DNA polymerase.

8. Add PCR enhancers such as BSA, betaine, DMSO, nonionic detergents, formamide or (NH₄)₂SO₄.

7. Switch to hot-start PCR.

6. Optimize your cycle number and cycling parameters, including denaturation and extension times.

5. Choose your primer sequences wisely.

4. Determine optimal DNA template quantity.

3. Clean up your DNA template to remove PCR inhibitors.

2. Determine the optimal annealing temperature of your PCR template.

1. Titrate the magnesium concentration!

I spent the rest of that semester, trying everything I could think of to optimize my reactions. I ground sea anemones, assembled amplification reactions and ran the resulting amplification products out on agarose gels.

And I assembled an entire notebook of empty gel images.

Are you trying to optimize your PCR amplifications? Or do you have a story of your own about the tricky nature of PCR? Share them in the comments below.

If you are facing your own uncooperative PCR target, this webinar offers more tips and tricks.

Finally, if you are looking for more information regarding PCR set-up, reference the supplementary video below.

The following two tabs change content below.

• Bio
• Latest Posts

Kelly Grooms

Scientific Communications Specialist at Promega Corporation

Kelly earned her B.S. in Genetics from Iowa State University in Ames, IA. Prior to coming to Promega, she worked for biotech companies in San Diego and Madison. Kelly lives just outside Madison with her husband, son and daughter. Kelly collects hobbies including jewelry artistry, reading, writing and knitting. A black belt, she enjoys practicing karate with her daughter as well as hiking, biking and camping.

Latest posts by Kelly Grooms (see all)

• Don’t Flush Your Kitty Litter! Toxoplasmosis Is a Growing Threat to Sea Otters and Other Marine Mammals - November 12, 2024
• Tardigrade Proteins Might Solve the Cold Chain Problem for Biologics - October 17, 2024
• Mpox—The Latest Zoonotic Virus Making Headlines - September 12, 2024